Manual Compressed Earth Block Machine Small Manual Cement Interlock Brick Machine/ Manual Fly Ash Brick Making Machine
Wood Chipper is one of the woodworking machines. it can make the wood into different small sizes as required . The Wood Chipping Machine is mainly used in pulp mill or Wood Veneer Dryer factory . Different model with different feeding size and different capacity. the wood chipper for Veneer Dryer is normally to chip the wood piece into size less than 5cm . which can ensure the efficiency of the burning rate .
Wood Chipper Wood Chipper Machine,Wood Chipper,Wood Chipping Machine,Wood Chipping Lines Shandong Shine Machinery Co.,Ltd , https://www.shinewoodmachine.com
The CEBM2 Machine uses a minimum amount of water to make bricks. The bricks can be made from either a mixture of soil and cement or subsoil only (depending on your requirements). This cuts out transport costs for crushed stone and sand.
The finished brick size is 300 mm x 150mm x 100mm. This can make standard 4-1/2 6 and 9 inch walls. Because they are made under high pressure (about 5Mpa) the bricks are solid, smooth-surfaced with high strength and good insulation properties compared with sand-cement bricks. Production is about 250 bricks per person on the team, ie.: 6 people in the team = 1500 per day. The limit is about 1200 bricks per machine per day.
The most common use of the bricks is in making 6 inch walls for single story buildings. The coverage is 30 per square metre.
One version of the CEBM2 Machine makes 2 stock bricks (the max size 300 x 150 x 100mm) at a time. This machine can also be used to mould Clay Bricks for firing. Fired clay stock bricks are frequently moulded with a method called "slop moulding". This requires a lot of work and water. Using a 2-Brick Terrabric Machine saves a lot of work, water and waste. There is less srinkage as there is less water put into the brick in the first place. Some clays are unsuitable for slop moulding because they shrink too much, but they can be used if they are pressed into shape by a 2-Brick QMR2-40 Machine before firing. The 2-Up version is more expensive, heavier, harder to operate correctly and produces a lower volume of bricks per day, however it makes some projects viable where no other technology will work.
Â
Over size
600*800*1100mm
Cycle
40-60s
Raw Material
soil or clay or clay with cement