Kaifeng natural gas boiler bag pulse single dust collector two meters bag ash leg lengthening effect
Ship Launching Airbags,Ship Launch,Ship Launching Rubber Airbag,Boat Launching Airbags Shandong Nanhai Airbag Engineering Co., Ltd. , https://www.nanhaimarine.com
The size of the top of the hopper depends on the size of the filter bag chamber. The dust removal capacity of the bag filter is measured by its total area of ​​filtration. The same filter area can be designed as a small ash bucket of a small filter bag room, and the number of rooms is relatively small. It can also be designed as a big filter bag room with a large ash bucket, and the number of rooms is small. When the dust hopper size is large, a guide plate should be installed inside the bucket, that is, the dusty gas entering the upper part of the ash bucket is made to pass through the deflector plate. Evenly into the filter bag type box or cloth bag, the structure of the deflector should be simple, and the welding volume in the bucket should be reduced. There are many accessories on the ash bucket of the baghouse dust filter on the \x0d bag. There is a vibrator, leveler, and overhaul. Manholes or air cannons are generally below the dust ash hopper. The ash hopper mouth is connected to the ash unloading valve. The angle between the sloping wall of the hopper and the ground is greater than the natural angle of repose of the bulk of the bucket.
There are many accessories on the dust collector of the bag filter. There are vibrators, levelers, overhaul manholes or air cannons, which are generally under the dust hopper. The ash bucket is connected to the ash discharge valve. The angle between the inclined wall of the hopper and the ground is greater than the natural angle of repose of the bulk of the bucket. The ash bucket and the lower steel frame pillars can be connected in various ways. Some pillars have a beam around the top of the pillar. The ash bucket's upper wall is welded directly to the girder. Some ash hoppers have four corners and are supported by a direct seat. On the stigma. This kind of ash hopper is reinforced by surrounding siding and is also made into a beam type. It weighs the weight of the filter bag box and the weight of the ash in the ash bucket. This type of structure is generally used in the lighter dust removal equipment of the upper box. It is advisable to design the dust hopper as a square or approximately square. The outer wall is stiffened in a ring and made of channel steel or angle steel. Between the stiffening of the ring there is a vertical stiffening, made of angle steel or flat steel, thin walls are stiffened, and the walls are stiffer and stiffer. Generally, the straight section of the ash bucket wall is smaller, the lower slope wall is very long, and it is vacant. The stiffness of the ash bucket must be considered. If the ash bucket is too long, the ash bucket can be subdivided to facilitate the manufacture, transportation, installation, and assembly. The flanges are connected between the sections, and the flanges are made of angle steel.
It can be seen that the length of the dedusting ash leg depends on many factors, such as the size of the ash hopper, the amount of ash stored, the installation space limit, and the unloading factor. For the entire dust removal equipment, any one part needs the designer's design. Once again, it is very important to prove that it is very important to install a dust collection equipment and select a manufacturer with a professional scientific research team.