Problems with slow water absorption in sprinklers
Product Description
GMP Drying Oven / Medicine Powder Drying Oven adopts noise elimination and thermal stable axial flow fan and automatic temperature control system. The entire circulation system is enclosed to make that the heat efficiency of the drying oven increases from 3~7% of the traditional drying oven to 35~45% of the present one. The highest heat efficiency can be up to 50%. The successful design of CT -C Hot Air Circulation Oven makes that the Hot Air Circulation Drying Oven in our country reach the advanced level in the world. It saves energy and increases the economic benefit.
Main Features
1. The heat source can be steam, electricity, far infrared, or steam+electricity. Customer can select one of the heating ways in accordance with practical conditions; 2.The temperature of operation: 50 ~ 140 °C for steam, Maximum temperature will be 150 °C; 3.50 ~ 350 °C for electricity or far infrared; 4. There are automatic and computer control systems for customer selection; 5. The normal pressure of steam will be 0.02-0.8MPa (0.2-8kg/cm 2); 6. The equipped power of electric heater will be 15kw Calculated with Model I and the operational power to be used will be 5-8kw/hr; 7. for special requirement, please indicate it in order; 8. The price of non-standard oven shall be discussed additionally; 9. If the operation temperature is more than 140 °C or less than 60 °C, please indicate it in order; 10. The size of drying trolley and tray is standardized. They can be exchanged each other; 11 The size of drying tray: 460 ×640×45(mm).
Characteristics
Most hot air is circulated in the oven. The Heat efficiency is high and the energy is saved. By using the forced ventilation function, there are adjustable air distribution plates inside the oven. The materials can be dried uniformly. The heating source might be steam, hot water, electricity and far infrared. With a widely selection. The whole machine is low in the noise. The operation is in balance. The temperature is controlled automatically. The installation and maintenance are easy. The application is wide. The machine can be used for drying various materials and is general drying equipment.
GMP Medicine Drying Oven, GMP Drying Medicine Oven, GMP Pharmaceutical Drying Oven, Drying Oven Changzhou Ruide Drying Engineering Technology Co., Ltd , http://www.rddryer.com
When the sprinkler cannot absorb water, please follow the following steps to test it step-by-step. First check whether the water pump outlet and outlet switch of the sprinkler pump is turned on. The sprinkler pump is a self-priming pump. When the water is used for the first time, the water should be poured. Check the front section of the suction tube. Whether there is debris in the filter clogging the inlet; paragraph by paragraph inspection of the inlet pipe is sealed, remove the fault of the leak; ordinary water truck pump used water diversion height should be less than 5 meters; check the sprinkler pump oil seal is damaged, pump Shaft leakage affects the degree of vacuum, seals should be replaced; sprinkler engine speed is too low, can not reach the required vacuum, adjust the throttle to make the speed at about 1700 rev / min, the gearbox may require different engine speed is different; Check whether the sprinkler power take-off is working or not. The power take-off and the drive shaft can cause the water pump to fail to work. Check whether the sprinkler water pump speed is normal and there is no abnormal noise. If you can't move it, there is a lot of debris around the blade.
Then avoid long-term idling of the pump in the process of detection, causing the pump temperature to be too high to affect its life 
