How to Protect Tanker Tyres at High Temperature

In the summer, there is always no chance of high-temperature weather. Then the tanker will have a chance to explode. This also makes the driver of the tanker inevitably shocked, for fear of accidents happen to him. So it's not a fault to drive a tanker ! Such hot weather is a very harsh test for automobile tires. The tire pressure has also become higher, directly affecting the safety of the vehicle, especially for vehicles with a large load. It is a severe test because of the high surface temperature. There are too many cases of causing the vehicle to catch fire during the driving process. The summer tanker tires have become the focus of attention of drivers. They have also been studying how to prevent other problems such as flat tires.

Today we introduce three most useful methods for everyone:

The first one: Be sure to choose the best quality tires and replace them at the right time. There are many reasons for tires, and the deterioration of tire performance is the culprit. Even if a set of tires is more durable, it cannot be used for a lifetime. When the tire wears gradually, the steel layer gradually fatigues, and the tread ages, its performance will inevitably weaken.

Article 2: Always check the tire pressure, including the tire pressure of the spare tire. In the scorching summer, the tires are in contact with hot surfaces. If the tire pressure is high, it may cause a puncture/fire. Therefore, do not allow the tire pressure to go too high at high temperatures, and check regularly if necessary.

Article 3: If it is found that the temperature of the tire and the pressure of the tire are too high, the way of deflation and splashing of cold water must not be adopted. Parking in a cool place should be selected so that the temperature and pressure of the tire will naturally drop.

Through these three most practical methods of controlling, it is possible to control the most powerful protection of the vehicle tires on the high-temperature ground. In the high-temperature summer, our main work is prevention, and prevention is the most important. Important, especially tanker vehicles of this type, are more important than anything else.

We can supply big range of such aluminum Casting Parts, including investment casting and Sand Casting and Die Casting

Sand Casting method (Sand Casting)

Using Sand as Mold material, according to the different components of Sand can be subdivided into wet Sand casting method of Green Sand Mold), surface Dry Sand casting method (Dry Sand Mold), and so on, but not all are available in the casting.

Advantage is lower cost, because the sand mold use reusable;

Metal mould Casting process (Die Casting)

Of the raw materials of high melting point metal production mold.The subdivided into gravity casting, low pressure casting method and high pressure casting method.

Under the control of the melting point of mold, can be molten metal is also limited.

Lost wax Casting, Investment Casting

This method can be as the outer membrane casting method and the solid casting method.

To copy wax casting items required first, and then into the pool with ceramic and stay dry, make with wax replica is covered a layer of ceramic outer membrane, repeat steps until enough to support outer membrane casting process (about 1/4 inch to 1/8 inch), then the wax melting mould, and out of mold. Then mold need to high temperature for many times, enhance behind the hardness could be used in the casting.

This method has good accuracy, can be used as a high melting point metal, such as titanium casting.

B. Main particulars

C. Construction

Construction by casting and machining

D Workmanship

The workmanship have good production practice. Care are taken to ensure High accuracy and smooth surfaces 

E. Certificates

- Material certificates

- Measuring reports

- Inspection protocol

- NDT reports

- Fixed certificate: ISO9001 certificate

Our service

Besides above the general specifications, we can also supply some specific machining parts as clients' requirements.

Package and shipping

Export cartons, pallets, wooden cases, Polybags

container package and container transportation

Aluminum Casting Parts

Aluminum Casting Parts,Oem Aluminum Casting Parts,Aluminum Sand Casting,Aluminum Casting Auto Parts

Shinvast Industry Ltd , http://www.shinvastindustry.com