Lime milk preparation post safety operation procedures

   1 Scope

This code specifies the operation content and safety requirements beneficiation plant milk of lime prepared.

This procedure applies to the lime ore preparation job of the concentrator.

2 content

2.1 Operators must be qualified after safety training; wear professional protective equipment such as helmets, dust masks and gloves before starting work. Employees must wear three tight dresses; women workers must be in safety helmets, not wearing shorts, high heels, and slippers.

2.2 Before preparing lime milk, special protective equipment must be worn. After adding water to the mixing tank, add lime.

2.3 Lime storage tanks, valves and pipelines should be kept sealed and free from leakage.

2.4 When cleaning the impurities of the lime milk in the mixing tank, it must have good ventilation conditions, take safety protection measures, fix the ladder, and have special personnel to monitor.

2.5 When lifting bagged lime, the safety regulations for lifting equipment should be observed.

2.6 It is strictly forbidden to switch electrical facilities with wet hands.

2.7 When opening, stopping and overhauling the lime milk pump, the “Plumbing Safety Operation Regulations” must be implemented.

2.8 Wear protective glasses during operation to prevent splashing of lime mud into your eyes.

2.9 Wash hands in time after the operation is completed. When the skin is in contact with the milk, rinse with water in time.

2.10 Responsible for the environmental sanitation of the scope of this post, clean and hygienic work, and achieve civilized production.

2.11 Fill in the original record carefully, and the writing is clearly intact.

2.12 Strictly implement the handover system.

Plug-in Wiper Arm

Is it Time to Change Your Windshield Wiper Arm?

All windshield wiper arms have a hinge at the base that allows the arm to flex as it follows the curvature of the window. If the wiper skips over certain spots, even with a new blade, chances are the hinge is binding from corrosion. It`s most common on rear window wipers since they`re used less often.

You can oil the hinge, but that`s just a temporary fix-the corrosion and binding usually return. To fix the problem permanently, replace the wiper arm (available at an auto parts store).

What you`ll need to replace your windshield wiper arm:

  • Socket/ratchet set
  • Flat-blade screwdriver

Now you`re ready to get started!

Plug-In Wiper Arm,Rear Window Wiper Arm ,Rear Windscreen Wiper Arm,Front Wiper Arm

COMOTECH ASIA PACIFIC (HANGZHOU)CO.,LTD , https://www.capwiper.com